Innovative
technology
– encapsulated microprocessor control
The youngest generation of the
most innovative type of control unit is located under
the covering bonnet of the Pull CR 24. Connecting clamps,
securing units and programming keys are accessible without
having to open the control casing. Thus, the electronic
board remains protected from rain and mechanical interferences
during start-up.
Easier connection
thanks to removable plug-in terminal strips
programmable
control
Programming an operator control has never been so convenient
and certain. Four keys, a large, illuminated LC
display and a clear-text menu guide control the very
user-friendly and time-saving programming of all functions.
electronic
limit-position identification
The Pull CR 24 operator automatically identifies the
gate’s end-position in the course of start-up
and stores it independently.
Soft
start-up and stopping
can be programmed separately and specially for opening
and closing motion. 1% increments between 25% and 100%
of the actual operating speed are possible. The gate
travel does not change with any adjustment.
fully
adjustable partial opening
This feature not only provides the classic doorway function
of 0.8 m but also a reduced opening for automobiles
and full opening for trucks in factory entranceways,
for example. Naturally, both are independently adjustable
via remote control.
connection
assistance
The display provides information in the course of start-up
on the correct connection and/or any eventual errors,
thus saving time.
safety
sensing edges
8.2 kOhm contact banks, separated for main and adjacent
closing edges can be directly connected to the Pull
CR 24 control, thus eliminating the need for a cost-intensive
switching unit. The display shows if a safety edge has
been triggered.
security
photocells
Even the photocell function can be defined freely in
the control to suit individual requirements.
