T O U S E K | automatic gate operators | products | sliding gate operators

PULL CR24

	- programmable control
	- example of usage
	- Tech. data
	- Brochure (PDF)

PULL SLR, CR

PULL X

other


		protective caps The elegantly styled coverings discreetly conceal the mounting bracket.

		lockable emergency release The operator bolts the door reliably. The emergency release unit – very important during times of electricity outage – is locked with a normal profile half-cylinder. It can be exchanged and thus be integrated into an existing house-key system. The cylinder and three keys are included as standard equipment.

		powerful motor - rapid door motion There are no unnecessary vibrations, thanks to the way the steel spindle and the rotor are made of a single piece; therefore, operation is very quiet. Other special features include high start-up torque, very little heat release and the resultant high degree of effectiveness.

		one-piece die-cast aluminium casing The entire gear assembly runs permanently in an oil bath, well protected together with the 24-volt motor and installed in a robust casing. Tempered toothed gearwheels and fully synthetic oil ensure long-term, maintenance-free operation.

		automatic illumination This function allows you to hook up your own on-site illumination for the building’s driveway. As soon as the actuator starts up, the function activates and switches off again automatically after an adjustable time of up to 15 minutes.

		economical The Pull CR24 helps to save valuable time and energy. The intelligent control switches off all consumers not required in standby mode; thus, power consumption is extremely low – only 1.1 watts.

Pull CR24
Apart from its longevity and rapid assembly, special attention was given to a high degree of security during operation when we designed the Pull CR 24 sliding gate operator. A special control system was developed. This automatically regulates the power requirements, which differ over the entire functional area. Thus, the motor provides only as much power as is actually needed.

Limitswitchless technology
The Pull CR 24 unit is equipped with an automatic device which “senses” the end position. Thus there is no need for regular mechanical end switches (which can freeze up in winter).

Safe with the ARS system
ARS stands for Automatic Reversing System. Should the gate meet an impediment, the operator stops at once and slides back automatically – the highest degree of safety.

Soft start and stop
The operator starts up slowly in both directions, also stopping at a reduced speed, not only making the door’s movements gentle but also sparing the entire mechanism of the door and the operator.